Walksnail Ascent Lite+ HD digital VTX kit｜BOOMFPV（炸机大叔）

01｜Main product photo / Click to view full image

02｜147° ultra-wide FPV view (official image) / Click to view full image

03｜Camera, VTX, and antenna (official photo) / Click to view full image

04｜Wiring definitions / Click to view full image

05｜Real-time audio recording with built-in mic (official image) / Click to view full image

06｜Power and installation / Click to view full image

07｜Bind indicators / Click to view full image

08｜Ascent system compatibility (official image) / Click to view full image

09｜Auto frequency hopping or manual tuning (official image) / Click to view full image

An HD digital VTX kit

Includes the camera, VTX, and antenna, up to 1080P/120FPS, maximum 500mW. 147° field of view, 16:9, 1/2.8-inch sensor, and a built-in microphone. Average latency is about 35ms and varies with conditions and the setup.

Installation and wiring

Input 3–12.6V. The VTX is 23.5×23.5×8mm, with a 20×20mm M2 mounting pattern. The camera is 12×14×15.8mm. VTX TX to flight-controller RX, VTX RX to flight-controller TX. Red is power, black is ground, white is VTX RX, gray is VTX TX. Install the antenna and keep the unit able to shed heat before you apply power.

Recording and compatibility

There is no onboard storage; recording uses a memory card in the receiver. Audio recording requires matching firmware and receiver, and 1080P100/120 does not support audio recording. Works with Ascent goggles or the Ascent VRX series. Not directly compatible with Avatar. Head tracking requires a separate compatible gimbal or similar device.

Factory accessories

The Lite+ kit, an upgrade cable, screws and washers, a screwdriver, double-sided tape, and a manual, subject to the factory list. Goggles, a receiver, a gimbal, and a memory card are sold separately. Ask us for purchase details.